Browsing by Issue Date

Sort by: Order: Results:

  • Rahman, Fouzia (Banaras Hindu University, Varanasi, India, 1986-08)
    The presented thesis entitled “ON MHD FLOWS OF VISCOUS INCOMPRESSIBLE FLUIDS” is being presented for the award of the degree of Doctor of Philosophy in Mathematics. It is the outcome of my researches conducted in the ...
  • Kazim, K. A. (Bangladesh University of Engineering and Technology (BUET), Dhaka, Bangladesh., 1986-09)
    Some strength characteristics of jute fibres, yarns, fibre bundles, yarn bundles, mats, and jute mat reinforced plastics, have been determined. The hardness, fatigue life, flexural modulus and percentage increase in ...
  • Mollah, Abdur Rahim (Robert Gordon's Institute of Technology, Aberdeen, Scotland, 1990-11)
    The work presented in this thesis is concerned with the development of a microprocessor based technique to detect and locate symmetrical and unsymmetrical faults on the interfacing network of a utility interconnected ...
  • Moral, Md. Nawsher Ali (Indian Institute of Technology (IIT), Kharagpur, India, 1990-12)
    Experimental investigations were made to study the effect of fin and vertical probe height on hydrodynamics and heat transfer in circulating fluidized beds (CFB). The experiments were conducted in a 100 mm I.D., 5.15 m ...
  • Ghosh, Dr. Bashudeb Chandra (Indian Institute of Technology (IIT), Kharagpur, India., 1992-07)
    The main subject matter of this dissertation is to develop parameter adaptive rotor flux oriented current fed induction motor drive systems for controlled speed operation. The parameter adaptive approaches do not require ...
  • Rahman, Md. Bazlar (Rajshahi University, Rajshahi, Bangladesh, 1994-08)
    This thesis studies the nature of distributive nearlattices. By a nearlattice S we will always mean a (lower) semilattice which has the property that any two elements possessing a common upper bound, have a supremum, Cornish ...
  • Hossain, Khandkar Aftab (Indian Institute of Technology (IIT), Kharagpur, India., 1996)
    In this investigation, the numerical solutions of Navier-Stokes equations and energy equation are presented for (1) laminar free slot jet, (ii) laminar free axisymmetric jet, (iii) laminar jet impingement on a circular ...
  • Alamgir, Muhammed (Saga University, Saga, Japan, 1996-03)
    A general method of analysis to solve an important class of problems encountered in the field of geotechnical engineering is developed in this dissertation. The analysis is formulated from the fundamental equation of ...
  • Azad, Dr. Md. Abul Kalam (Indian Institute of Technology (IIT), Kharagpur, India., 1996-04)
    The primary objective of generation expansion planning is to meet the electrical energy needs of the customers as economically as possible with an acceptable degree of safety, reliability, and quality. Power system ...
  • Hossain, Dr. Md. Monjur (Bangladesh University of Engineering and Technology (BUET), Dhaka, Bangladesh., 1997-05)
    The composite action between masonry wall and its supporting beam concentrates the vertical loading applied on the top of wall close to the beam supports. This produces bending moments much less than would be expected ...
  • Rahman, Dr. A. N. M. Mizanur (Indian Institute of Technology (IIT), Kharagpur, India., 1997-09)
    Assessment of techno-economic viabiity of solar energy systems is based on long term performance. The popular design methods for active as wel1 as passive solar energy systems require certain proprocessed parameters in ...
  • Alam, Dr. Md. Mahbub (Dhaka University (DU), Dhaka, Bangladesh., 1998-12)
    Rawindsonde data of 0000 UTC for standard isobaric surfaces at the surface, 850, 700, 500, 400, 300, 200, 150 and 100 hPa levels for the periods of different cyclones in the last decade were considered to study the ...
  • Sikder, Shibendra Shekher (Bangladesh University of Engineering & Technology (BUET), Dhaka, Bangladesh, 1999-07)
    Ferromagnetic amorphous ribbons of Fe-Si-B, Ni-Fe-B and Co-Fe-B-Si series have been prepared by rapid quenching technique and the amorphousity of the samples has been confirmed by X-ray diffraction technique. The kinetics ...
  • Bhowmick, Tarapada (Indian Institute of Technology (IIT), Kharagpur, India, 1999-08)
    Electrochemical grinding (ECG) has become more and more important for its industrial use, in machining problems associated with grinding hard and wear resisting and even very soft electrically conductive materials. In a ...
  • Islam, Md. Nurul (Bangladesh Institute of Technology (BIT), Khulna, 2000-08)
    An experimental investigation was carried out to investigate the pressure distribution and the local and average Nusselt number due to impinging of a circular air jet over uniformly heated rough flat surfaces. The present ...
  • Alam, Dr. Firoz (RMIT University, Melbourne, Australia., 2000-09)
    A desirable requirement in the production of modern vehicles world-wide is the provision of a high level of driving comfort. An important aspect of this is the minimisation of aerodynamic noise. As structure-borne, engine, ...
  • Rafiq, Md. Abdur (Bangladesh Institute of Technology (BIT), Khulna, Bangladesh., 2001-03)
    The main subject matter of this dissertation is to study the performance of artificial neural network and observer based high performance induction motor drive. Four suitable flux observers compatible with drive control ...
  • Masum, Mir Md. Al (Bangladesh Institute of Technology (BIT), Khulna, Bangladesh., 2001-11)
    Piles are used to transfer the loads from the superstructure down to the soil stratum. where the required resistance is available. Unless a single pile is used, a pile cap is necessary to spread the vertical and horizontal ...
  • Bashar, Md. Abul (Bangladesh University of Engineering & Technology (BUET), Dhaka, Bangladesh, 2002-03)
    A considerable development activity within the Coastal Region of Bangladesh has necessitated an understanding of the geotechnical behaviour of soils from this region. With this objective in view a study into strength-deformation, ...
  • Das, Santosh Kumar (Bangladesh Institute of Technology (BIT), Khulna, Bangladesh., 2002-05)
    Methodologies are presented in this thesis to study the coordination among the protective devices and voltage drops at different points of a radial distribution system. Maximum and Minimum values of currents due to ...